Komatsu PC210-6K — 24.5 EVERY 250 HOURS SERVICE

24. SERVICE PROCEDURE 24.5.6 CHECK AIR CONDITIONER TENTION, ADJUST COMPRESSOR BELT Checking The belt should normally deflect by about 5 - 8 mm (0.20 0.31 in) when pressed with the finger (with a force of approx. 6kg (13 Ib)) at a point midway between the drive pulley and compressor pulley. AW354520 Adjusting 1. Insert a tension adjusting bar wrapped with cloth cushioning material between brackets @) and ©@. bolts @ Tension adjusting bar or another 2. Loosen and ®. 3. Move bracket @ with the tension adjusting bar so that deflection of the belt will be 5 — 8 mm (0.20 — 0.31 in). the AW354538 4. Tighten bolts @ and @ to secure bracket @. Then, take out the tension adjusting bar. 5.

Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 6. Replace belt if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on belt. 7. When the new belt is set, readjust it after operation for an hour. 3-57