24. SERVICE PROCEDURE 24.5.5 CHECK FAN BELT TENSION, ADJUST Checking The belt should normally deflect by about 5 - 6 mm {0.20 0.24 in) when pressed with the finger (with a force of approx. 6 kg (13 Ib) at a point midway between the fan pulley and tension pulley. Adjusting 1. Loosen 2. bolts and nuts G) and Fan @). Loosen locknut G) and use adjustment bolt @ to move tension pulley @ to adjust the belt tension so that the deflection is approx. 5 —- 6 mm (0.20 — 0.24 in) when pushed at portion A (with a force of approx. 6 kg (13 Ib)). Tighten the lock nuts ©), bolts © and nuts @ to fix tension pulley @ in position. Check each pulley for damage, wear of the V-groove, and wear of the V-belt.
In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. Replace 2 belts if it has stretched, leaving no adjustment, or if there is a cut or crack on belt. When 3-56 pulley allowance for the new belt is set, readjust it after operation for an hour. Tension Crank pulley pulley AW34963B