24. SERVICE PROCEDURE 24.6.6 REPLACE HYDRAULIC FILTER ELEMENT AWARNING When removing the oil filler cap, turn it slowly to release the internal pressure before removing 1. Remove the cap from oil it. filler ©, and release the internal pressure. 2. Loosen 4 bolts, then remove cover (). When doing this, the cover may fly out under the force of spring @, so hold the cover down when removing the bolts. 3. After removing 4. Clean 5. Install a new installed. 6. Set valve @ and spring @ on top of the element. 7. Set cover @ in position, push it down cover with the mouning bolts. 8. Screw in the oil filler cap and install the cover. 9.
To bleed the air, start the engine according to “12.2 STARTING ENGINE” and run the engine at low idling for 10 minutes. spring @ the removed and valve @), take out element @. parts in diesel oil. element in the place where old element by hand, and @ was install the 10. Stop the engine. REMARK Operate the machine after halting for more eliminate bubbles in the oil inside the tank. to off any spilled oil. 5000 earlier than in normal bucket digging work. The first element replacement should be at 100 to 150 hours for new machines. Thereafter, replace the element according to the table on the right. Replace the additional filter element for the breaker every approx.
250 hours (when breaker operating ratio is more than 50%) according to the table on the right. (See BREAKER “24.2.11 REPLACE ADDITIONAL FILTER ELEMENT”.) NOTICE e e 3-62 If the machine is equipped with the hydraulic breaker, be sure to install an additional filter to the return circuit. When it is obliged to use the breaker horizontally in a tunnel, etc., check the hydraulic oil periodically by OIL CLINIC to prepare and to carry out the oil replacement program matched to the jobsite. | (H) When the hydraulic breaker is installed, the hydraulic oi] deteriorates interval and wipe 5 minutes Replacement 11. Check for oil leakage than 4000 \ 3000 Replacement interval for hydraulic oil — 2000 f.
1000 500 0 (When not using breaker} F Additional filter 40 60 element 80 1250 100 Breaker operating ratio (%) (When using Hydraulic filter breaker only) elenent AW35414B