24. SERVICE PROCEDURE 24.7 EVERY 1000 HOURS SERVICE Maintenance for every 100, 250 and 500 hours should be carried out at the same time. 24.7.1 CHANGE OIL IN SWING MACHINERY CASE AWARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before carrying out maintenance. e e Container to catch drained oil: Min. 5.5 2 capacity Refill capacity: 5.5 2 (1.45 US gal, 1.21 UK gal) 1. Set an body. 2. Loosen drain valve ® under the body, drain the oil, then tighten the drain valve again. 3. oil container Remove Add under drain valve ®) under the machine dipstick @ and bleeding plug ©. the specified amout of engine oil through gauge hole ©.
NOTICE For details of the oil to use, see “20. USE AND LUBRICANTS ACCORDING 4. After refilling, install bleeding 5. Wipe 6. OF FUEL, COOLANT TO AMBIENT TEMPERATURE”. plug @. off oil on the dipstick with a cloth. Insert dipstick @ into the gauge pipe thoroughly and then pull out it again. 7. When the oil level is between the H and L marks, on dipstick @, it is normal. If the oil does not reach the L mark, add more oil through oil filler ©. 8. If the oil level exceeds the H mark, drain the excess engine oil from drain valve ®, and check the oil level again. 3-63