24. SERVICE PROCEDURE 24.8 EVERY 2000 HOURS SERVICE Maintenance for every 100, 250, 500 and carried out at the same time. 24.8.1 CHANGE 1000 hours should be OIL IN FINAL DRIVE CASE AWARNING e The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before carrying out maintenance. e If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare the following. Container to catch drained oil: Min. 4.2 @ capacity Refill capacity: 4.2 2 (1.11 US gal, 0.92 UK gal) Handle 1. Set the TOP mark at the top, with the TOP perpendicular to the ground mark and plug © surface. 2.
Set a container under plug © to catch the oil. 3. Remove plugs ® and © with the handle and drain the oil. REMARK Check the O-rings in the plugs for damage. If necessary, replace with new ones. 4. Screw in plug ®. 5. Add engine oil through the hole of plug ©. NOTICE For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 6. When the oil overflows from the hole of plug ©, install plug ©. Tightening torque of plugs ® and ©): 70 + 10 Nm (7 + 1 kgm, 50 + 7 Ibft) 3-66 AN114750