24. SERVICE PROCEDURE 24.8.2 CLEAN HYDRAULIC TANK STRAINER AWARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before cleaning the strainer. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it carefully. 1. Loosen 4 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring @, 2. 3. so push the cover down when removing Pull up the top of rod @), and remove the bolts. spring @) and strainer @). Remove the dirt stuck to strainer @, then wash it in clean diesel oil or flushing oil. If strainer @ is damaged, 4. Refit strainer @ 5.
Install cover @ with 24.8.3 CLEAN, Contact your 24.8.4 CHECK replace by inserting it with a new AE313900 one. it into tank projecting part ©. bolts. CHECK TURBOCHARGER Komatsu distributor for cleaning ALTERNATOR, STARTING or inspection. MOTOR The brush may be worn, or the bearing may have run out of grease, so contact your Komatsu distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1000 hours. 24.8.5 CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, you shall request Komatsu distributor for service. 3-67