Komatsu PC210-6K — 7.2 AFTER STARTING ENGINE

@ WARNING: Failure to follow these safety precautions may lead to a serious accident. PARKING @ 7. PRECAUTIONS DURING OPERATION MACHINE Park the machine on level ground where there is no danger of falling rocks or landslides, or of flooding if the land is low, and lower the work equipment to the ground. @ If itis necessary to park the machine on a slope, set blocks under the tracks to prevent the machine from moving, then dig the work equipment into the ground. e After stopping the engine, operate the right work equipment control lever several times to the RAISE and LOWER positions to release the remaining pressure in the hydraulic circuit.

@ When parking on public roads, provide fences, signs, flags, or lights, and put up any other necessary signs to ensure that passing traffic can see the machine clearly, and park the machine so that the machine, flags, and fences do not obstruct traffic. Parking procedure —~ See “12.17 PARKING MACHINE”. e@ When leaving the machine, set the safety lock lever @ to the LOCK position, stop the engine, and use the key to lock all the equipment. Always remove the key and take it with you. Work equipment posture —~ See “12.17 PARKING MACHINE”. Locks — e Always See “12.21 LOCKING”. close the door of the operator's compartment. CORRECT .

# Thrust the bucket PRECAUTIONS e After Lock o ; AN113060 AB305768 IN COLD AREAS completing operations, remove all water, snow, or mud connector (1, switches, or sensors, and cover these parts. if the water freezes, it will cause malfunctions of the machine lead to unexpected accidents. stuck to the when wiring harness, it is next used, which may e Carry out the warming-up operation thoroughly. If the machine is not thoroughly warmed up before the control levers are operated, the reaction of the machine will be slow, and this may lead to unexpected accidents.

@ Operate the control levers to relieve the hydraulic pressure (raise to above the set pressure for the hydraulic circuit and release the oil to the hydraulic tank) to warm up the oil in the hydraulic circuit. This ensures good response from the machine and prevents malfunctions. e |f the battery electrolyte is frozen, do not charge the battery or start the engine with a different power source. There is danger that this will ignite the battery. When charging or starting the engine with a different power source, melt the battery electrolyte and check for leakage of battery electrolyte before starting. Battery charge rate ~ See “14. COLD WEATHER OPERATION”. AE305820 1-17