12. OPERATION CHECK AIR CLEANER FOR CLOGGING 1. Confirm that the air cleaner clogging monitor does not flash. 2. If it flashes, immediately clean or replace the element. For details of the method of cleaning the element, see “24.2.1 CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT”. AD313590 CHECK ELECTRIC WIRINGS A WARNING If fuses are frequently blown or if there are traces of short circuit on the electrical wiring, locate the cause and carry out repair. Check for damage of the fuse and any sign of disconnection or short circuit in the electric wiring. Check also for loose terminals and tighten any loose parts. Check the following points carefully.
e Battery e Starting motor e Alternator Please contact your correction of the cause. Komatsu distributor for investigation and A WARNING Accumulation of flammable material (dead leaves, twigs, grass, etc.) around the battery may cause fire, so always check and remove such material. When carrying out walk-around checks or checks before starting, always check around LUBRICATE @ 1. 2. if there is any accumulation the battery, and CLAMSHELL Using a grease of flammable such flammable material material. BUCKET Prepare a grease pump. Place the work equipment then stop the engine. fittings shown 3. remove pump, in a stable pump in posture grease on through the ground, the grease pushed out.
by arrows. After greasing, wipe off any old grease that was AN113850 2-47