12. OPERATION CHECK FOR WATER DRAIN WATER AND SEDIMENT IN WATER SEPARATOR, The water separator separates water mixed in the fuel. If float @ is at or above red line @), drain the water according to the following procedure: 1. Loosen drain plug @ and drain the accumulated float reaches the bottom. water until the AE082240 2. Tighten drain plug ©. 3. If the air is sucked into fuel line when draining and water, be sure to bleed air in the same manner as for the fuel filter. See “24.6 EVERY 500 HOURS SERVICE”. 12.1.3 ADJUSTING SEAT POSITION A WARNING e Adjust the seat position at the beginning of each shift or when operators change.
e Adjust the seat so that the travel pedal can be depressed all the way with the operator’s back against the backrest. OPERATOR’S SEAT @® Fore-and-aft adjustment of seat Pull lever G) up. release the lever. Adjustable distance: After the seat is set to the desired position, 100 mm (3.9 in) in 10 steps of reclining for the seat is greatest when the seat Adjustment of reclining seat NOTICE The amount is moved forward, and becomes smaller as the seat is moved to the rear. For this reason, when moving the seat to the rear, set the seat back to the upright position. Pull lever @ up. After the seat back is set to the optimum for easy operation, release the lever.
position Sit with your back against the seat back when adjusting. If your back is not touching the seat back, the seat back may suddenly move forward. © Adjusting seat tilt 1. Forward tilt (LJ) Push lever @ down and adjust the angle at the front of the seat. (4 stages) 1. 2. 2-48 To raise the angle at the front of the seat, keep the pushed down and apply your weight to the rear of the To lower the angle at the front of the seat, keep the pushed down and apply your weight to the front of the lever seat. lever seat. @: option AM2 13610