REPAIR AND REPLACEMENT OF PARTS REPLACING MAIN BEARING CAP REPLACING MAIN BEARING CAP When replacing the main bearing cap, machine the semi-finish product to the following dimen- sions, then install. Correction parts 1. Machining inside diameter of main bearing cap 1) Remove the cylinder liner. 2) Install the replacement main bearing cap to the cylinder block, and tighten to the speci- fied torque. 2 Main bearing cap mounting bolt: Coat seat face of threaded portion with engine oil 3 Main bearing cap mounting bolt: Unit: Nm {kgm} 615002 fl Align the cylinder block and main bear- ing cap notch.
3) Set a cylinder block mounting jig on the ta- ble of a horizontal boring machine, fit the cylinder liner mounting hole of the cylinder block to the standard line on the jig, and install the cylinder block. 4) Of the main bearing caps to be used again, take the one with the longest pitch and put a dial gauge in contact with the inside diam- eter at two places to align the center of the boring machine arbor. 15-18-2 8 15-18-2 (10) Part No. Part Name 6150-29-1210 Main bearing caps other than No. 7 6150-29-1250 No. 7 main bearing cap Order Target Range 1st step 98 {10} 88 – 108 {9 – 11} 2nd step 196 {20} 191 – 201 {19.5 – 20.5} 3rd step Tighten a further 90° 90°+30° 0