Mitsubishi SA6D125 — REPLACING MAIN BEARING CAP

REPAIR AND REPLACEMENT OF PARTS REPLACING MAIN BEARING CAP 5) Check the machined inside diameter of bear- ing cap (1) and grind a little at a time. fl Grind until the bit touches the inside surface of cylinder block (2). fl Inside diameter of main bearing cap 1 Machining dimension Tolerance: 116 mm 2 Inside diameter of cap when main bearing cap is tightened to specified torque after machining Tolerance: 116 mm +0.015 0 +0.013 –0.009 (Up-down range of 10° at mating surface of main bearing cap) fl Finishing roughness: Within 10 S fl Do not grind the inside face of the cylin- der block. 2. Machining width of main bearing cap (Only when machining No.

7 main bearing cap) 1) Insert cast iron bushing 1 , then pass arbor 2 through. 2) Install facing bit 3 to the arbor. 3) Grind A portion of cap (1) until the bit touches the cylinder block (2) face. 4) Grind B portion of the opposite side in the same way. fl Roughness of thrust bearing mounting sur- face: Within 12.5 S fl Do not grind the cylinder block. fl Width of main bearing cap Tolerance: 38 mm 615002 + 0 –0.025 15-18-3 8 15-18-3 (10)