Resistance Testing 1. Disconnect both ends of ignition cable (rotate boot and pull at the boot only) being tested and clean terminals. 2. Set ohmmeter on high scale and connect ohmmeter to each end of cable being tested. Twist cable gently while observing ohmmeter. 3. If ohmmeter reads above 25,000 ohms or flucuates from infinity to any value, replace cable being tested. 4. If the resistance of each cable is not within the following bands, replace the cable being test-ed. 0 to 15 inch cable................. 3,000 / 10,000 Ohms 15 to 25 inch cable............... 4,000 / 15,000 Ohms 25 to 35 inch cable...............
6,000 / 20,000 Ohms Spark Plug Wire Routing Spark Plug Inspection (3) Spark plug. 4. During installation of the spark plug wires, makesure the wire terminals make good connections inthe distributor cap and on the spark plugs. Inspectspark plug (3) insulator for cracks. Clean the sparkplug of any oil or dirt before installation. Inspection of Spark Plug Wires General Description The spark plug wires are a carbon-impregnatedcord conductor encased in an 8 millimeter diameter silicone rubber jacket. Silicone wiring will withstand very high temperature and is an excellent insulator for the higher voltages. Silicone is soft, pliable, and therefore, more susceptible to scuffing and cutting.
It is extremely important that the spark plug cables be handled with care. They should be routed so as not to cross each other, or be in contact with, other parts of the engine to prevent rubbing. NOTICE: For proper operation, it is necessary to keep ignition wires and distributor clean and free of any dirt or corrosion. G643(E) Service Manual Chapter 4. Engine Electrical System 116