Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Inspection of Spark Plug Inspection and clean 1. Disconnect the ignition wires from the ignition coil ass’y. 2. Remove all spark plugs from the cylinder head using a spark plug wrench. 4. Check the plug clearance using a plug clearance auge and if the value is not within the specified values, adjust it by bending the ground clearance. When installing a new sparkplug, install it after checking the uniform plug clearance. 5. Install the spark plug and tighten it to the specified torque. Take care not to over tighten it to prevent cylinder head threads from damage. Spark Plug Analysis Take care not to come foreign materials into spark-plug mounting hole. 3. Check the spark plug as below.

1) Insulator broken 2) Terminal worn 3) Carbon deposit 4) Gasket damaged or broken 5) Porcelain insulator of spark plug clearance G643(E) Service Manual Chapter 4. Engine Electrical System 117 CAUTION Spark plug clearance 0.8 ~ 0.9 mm Tightening torque 30 N· m State Contact point is black Contact point is white Description • Density of the fuel mixture is thick • Lack of air intake • Density of the fuel mixture is thin • Ignition timing is fast • Spark plug is tight • Lack of torque