EST Distributor Remove Distributor 1. Disconnect coil harness (1) from distributor. 2. Bring the engine to TDC on the compression stroke before removing the distributor. 3. Remove the coil wire, spark plug wires (3) and cap (4) from the distributor. NOTE: Scribe an alignment mark on the distributor and intake manifold to show the position of the rotor. 4. Remove the bolt, distributor clamp, and distributor. Install Distributor 1. Install the distributor (1) in position in the intake manifold. Make sure that the rotor (2) is in alignment with the scribe mark and number one cylinder. 2. Install the distributor clamp and bolt to the distributor. 3.
Install cap (4) and plug and coil wires to the distributor. 4. Connect the coil harness to the distributor and the coil wire to the coil.5.Check the ignition timing. (See Test and Adjustment) G643(E) Service Manual Chapter 4. Engine Electrical System 121