Inspection of Ignition Coil 1. Connect ohmmeter between "B+" or "C-" terminals and ground (coil-mounting bracket). On high scale, reading should be infinite (test 1, IAGS004S). 2. Connect ohmmeter between "B+" and "C- "terminals. On low scale, reading should be nearly zero (approximately 0.4 ohm) (test 2, IAGS004S). 3. Connect ohmmeter between "B+" or "C-" terminals and coil high-voltage tower. On high scale, reading should be approximately 8000 ohms. Reading should not be infinite(test 3, IAGS004S). NOTICE On tests 2 and 3, reading may vary slightly depending on coil temperature. 4. If reading is not within specification, replace coil.
Disassembly and Assembly Ignition Coil Remove & Install Coil 1. Disconnect wire connectors (1) from the coil. 2. Remove two bolts from coil mounting bracket and remove the coil. NOTE: For installation of the coil, reverse the removal steps. G643(E) Service Manual Chapter 4. Engine Electrical System 120