Pickup Coil Testing 1. Remove The distributor cap and rotor. 2. Disconnect the pickup coil leads from the module. 3. Connect an ohmmeter between the pickup coil lead and housing (test 1, IAGS059S). Reding should be infinite (no continuity). 4. Connect an ohmmeter to both pickup coil leads (test 2, IAGS059S). Reading should be a constant, unchanging value between 500-1500 ohms. Flex leads by hand at coil and connector to locate intermittent opens. Replace pickup coil if not within specifications. Test 1 Tester Connections Test 2 Tester Connections G643(E) Service Manual Chapter 4. Engine Electrical System 119