Ignition Timing Adjustment for G643 Engine The ignition timing advance of G643 is controlled by the SECM. The initial ignition timing setting of the distributor is described in the following steps. It will be necessary to mechanically adjust the distributor to an initial setting for startup, and then adjust the final timing using the Service Tool. 1. Be sure engine is turned OFF. 2. Remove distributor cap (Figure 34) . 3. Disconnect the fuel lock-off connector at the lock off so that fuel cannot flow during cranking. 4. Disconnect the 4-pin connector (Figure 35) to the ignition module.
This eliminates the +12 Vdc power on Pin D and puts the ignition to a default value not controlled by the SECM. 5. Connect standard inductive timing light (Figure 36) to the #1 cylinder. 6. Manually bar the engine so that the timing indicator on the crankshaft pulley lines up to 0° Top Dead Center (TDC) of the #1 cylinder (Figure 37) . 7. Verify that the distributor rotor is lined up with #1 cylinder on the distributor cap (Figure 38) . Figure 35. Four-Pin Connector to Ignition Module Figure 36. Standard Inductive Timing Light 8.
Using standard inductive timing light with no offset adjustment set the initial timing to 4° BTDC (advanced) by rotating the distributor while cranking the engine with the ignition key. 9. Tighten the distributor hold-down bolt to the specified torque value and re-connect the 4-pin ignition module connector and the fuel lock-off connector. Figure 37. Engine Set at 0° Top Dead Center (TDC) DISTRIBUTOR IGNITION MODULE 1 (1) lgnition Coil. (2) lgnition Module. Figure 34. GM Ignition Module G643(E) Service Manual Chapter 4. Engine Electrical System 123