Figure 38. Topside of Engine Showing Position of Cylinders NOTE: This completes the initial ignition timing. The final ignition adjustment can be made at engine start-up using the software Service Tool. Final Timing Verification To verify the mechanical timing adjustment of the distributor you will need to lock the spark using the Service Tool Test Screen and use the timing light to verify adjustment. NOTE: Service Tool software (Moto TuneViewer) and the security Crypt Token is obtainable by certified technicians through authorized dealers. 1. Without starting the engine turn the Key switch to the ON position and open the Service Tool Display Test Screen.
The Spark Control Lock parameter should be “Unlocked” as in (Figure 42). The Spark Offset should read 0.00 and “OFF” in the Units column of the display. When a value is entered in the Spark Offset, the offset value is added to the value displayed in the Spark Advance parameter. NOTE: You must always return the Spark Offset value to 0.00 before closing the Service Tool or the offset will be applied during engine operation causing inaccurate ignition timing with the possibility of misfire or engine damage. Figure 42. Spark Control Lock Parameter “Unlocked” 2. The preferred reference timing to use for verification with a timing light is 10 degrees BTDC.
In Figure 42 the Spark Advance with the engine not running is 5.0° BTDC. To lock the spark at 10° BTDC a Spark Offset value of 5.0 would need to be entered (5.0 + 5.0 = 10). Enter the appropriate offset value that will equal 10 when added to your engine’s spark advance. (10 – Spark Advance = Spark Offset). Once an offset value is entered the “OFF” description will change and display “WARNING” to alert you that the offset value is not set to 0.00. Figure 43. Spark Control Lock Parameter “Locked” 3. Select the Spark Control Lock “Unlocked” check box. The check box display will change to read “Locked” as in Figure 43.
You have now locked the SECM ignition timing at a fixed value (Spark Advance + Spark Offset). G643(E) Service Manual Chapter 4. Engine Electrical System 124