4. Start the engine, using the timing light verify the engine is running at the correct timing, in this case 10° BTDC. If it is not 10° BTDC loosen the distributor hold down bolt and slightly adjust the distributor for 10° BTDC using your timing light. Tighten the distributor hold down bolt. 5. Un-check the Spark Control Lock, it should now read “Unlocked” as in Figure 42 allowing the SECM to control spark advance. 6. Enter 0.00 in the Spark Offset, the Warning message should now read OFF as in Figure 44. The SECM is in full control of the spark advance with no offset. 7. Setting the distributor position is now complete. Figure 44.
SECM in Full Control of Spark Advance Ignition Timing Adjustment for G643E Engine On G643 engine, crankshaft position was sensed from the distributor. Adjusting the distributor has a direct affect on ignition timing - 1 degree of the distributor rotation would produce a 2 degree change in spark timing. G643E engine senses crank position from the crank position sensor and the target wheel. Rotating the distributor will not directly affect ignition timing, except in extreme conditions. When engine is disturbed and ignition timing is incorrect, inspect the sensors concerned with ignition timing, at first. [Figure] Crank Position Sensor of G643E Engine NOTE:
Affective SECM input to ignition timing control • Coolant temperature sensor • Oxygen sensor • Battery voltage • MAP sensor (Engine load) • Crankshaft position sensor • Throttle position sensor • Intake Air Temperature sensor If the distributor is severely misaligned, the rotor will not properly align with the distributor cap and spark will misfire or go to the wrong cylinder. When replace the distributor, install new distributor as follows; 1. Install distributor shaft into engine, aligning marks made at time of removal (see, figure). Be sure that the shaft engages oil pump 2. Secure distributor with clamp 3. Install distributor cap G643(E) Service Manual Chapter 4.
Engine Electrical System 125