Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

2. Turn the ignition switch OFF. 3. Disconnect the battery ground cable. 4. Disconnect the alternator output wire from the alternator “B” terminal. 5. Connect a DC ampere meter (0-100V) between “B” terminal and the disconnected output wire. Connect (+) lead wire to the terminal “B” and (-) lead wire to the disconnected output wire. NOTE: Do not use clips or equivalent owing to high current and Use bolts and nuts to tighten each connecting part securely. 6. Connect a volt meter (0-20V) between “B” terminal and the ground. Connect (+) lead wire to the alternator “B” terminal and (-) lead wire to the proper position. 7. Connect the engine tachometer and then battery ground cable. 8.

Be sure that the hood is opened. Test 1. Be sure that voltmeter reading is identified with battery voltage. If voltmeter reading is 0V, it means short circuit of wire between “B” terminal and the battery (-) terminal, fusible link cut off or ground fault. 2. Turn the headlight ON and start the engine. 3. With the engine running at 2,500 rpm, turn ON the high beam headlights, place the heater blower switch at ”HIGH” measure the maximum output current using a ammeter. NOTE: This test should be done as soon as possible to measure the exact maximum current because output current drops rapidly after starting the engine. Result 1. Ammeter reading should be as same as the load.

If the reading is low even though the alternator output wire is normal, remove the alternator from the vehicle and inspect it. NOTE: Output current varies according to electrical load or temperature of the alternator, so during test, lack of electrical load causes impossibility of measuring the rated output current. In this case, turn on headlight to induce the battery discharging or turn on other lights to increase the electrical load. If alternator temperature or ambient temperature is too high, it is impossible to measure the rated output current, so prior to re-test, necessarily drop the temperature. 2.

After test, adjust the engine speed at idle and turn the light and ignition switch OFF. 3. Disconnect the battery ground cable. 4. Disconnect the ammeter and voltmeter. 5. Connect the alternator output lead wire to the alternator “B” terminal. 6. Connect the battery ground cable. G643(E) Service Manual Chapter 4. Engine Electrical System 133 Output current As same as Elecrical load Ambient temperature of voltage regulator(℃) Voltage adjust(V) -30 14.5 ~ 15.4 25 14.3 ~ 14.9 60 14.0 ~ 14.8 90 13.6 ~ 14.6