Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Troubleshooting Starting system problem can be classified into “Start motor is not operating”, “Start motor is operating but engine is not starting” , and “There is a lot of time taken to start engine”. When the starting system has problems, before removing the start motor, find where the problem happens. Generally if it is difficult to start, there are problems in ignition system, fuel system, and electrical system. In this case, necessarily inspect and repair step by step, or the same problem will happen. G643(E) Service Manual Chapter 4.

Engine Electrical System 138 Symptom Possible cause Remedy Impossible cranking Low battery charging voltage Charge or replace Loose, corroded or worn battery cable Repair or replace Inhibitor switch fault Adjust or replace Circuit breaker cut off Reset or replace Start motor fault Repair Ignition switch fault Replace Slow cranking Low battery charging voltage Charge or replace Loose, corroded or worn battery cable Repair or replace Start motor fault Repair Continuous rotating of start motor Start motor fault Repair Ignition switch fault Replace Start relay fault Replace Start motor is rotating but engine is not cranking Short circuit of wiring Repair Worn or broken pinion gear tooth or motor fault Repair Worn or broken ring gear tooth Replace flywheel ring gear or torque converter