Starter Repair Removal Remove or disconnect Always disconnect the cable at the battery before you make repairs to the engine. Disconnect the cable at the negative terminal first. Install a tag on the battery terminals first. Install a tag on the battery terminals so that no one connects the cable on the terminal. 1. Discount battery negative cable at negative terminal. 2. Disconnect the battery positive cable at positive terminal. 3. Put labels on wires and cables prior to disconnecting to aid in correct installation. 4. Disconnect wires and cables from starter. 5. Hold starter so it won’t fall. Remove capscrews that fasten the starter to the flywheel housing.
Install capscrews to fasten the starter to the flywheel housing. Installation Install or connect 1. Place starter in position in flywheel housing. Install capcrews to fasten the starter to the flywheel housing. Tighten cap screws to 38 N•M (28 lb•ft) 2. Connect wires and cables as labeled in removal. 3. Connect the battery positive cable at positive terminal. 4. Connect battery negative cable at negative terminal. G643(E) Service Manual Chapter 4. Engine Electrical System 139 WARNING