Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

MI-07 System Components • Min/max governing • All-speed isochronous governing • Fixed-speed isochronous governing with three switch-selectable speeds • Spark timing modifiers for temperature and fuel type • Input sensor selection and calibration • Auxiliary device control for fuel pump, fuel lock-off solenoid, tachometer, MIL, interlocks, vehicle speed limiting, etc. • CANBus data transfer for speed, torque, etc. The MI-07 control system provides electronic control to the following subsystems on mobile industrial engines:

• Spark-ignition control system • Air throttle • Sensors/Switches/Speed inputs Key Components The MI-07 system functions primarily on engine components that affect engine emissions and performance. These key components include the following: • Engine/Combustion chamber design • Intake/Exhaust valve configuration, timing and lift • Intake/Exhaust manifold design • Throttle body • Air intake and air filter • LPG mixer • LPG pressure regulator • Small engine control module (SECM), firmware and calibration † • Fuel system sensors and actuators • Ignition system including spark plugs, cables, coils and drivers MI-07 System Features Other system features include:

Tamper-Resistance Special tools, equipment, knowledge, and authorization are required to effect any changes to the MI-07 system, thereby preventing unauthorized personnel from making adjustments that will affect performance or emissions. Diagnostics MI-07 is capable of monitoring and diagnosing problems and faults within the system. These include all sensor input hardware, control output hardware, and control functions such as closed-loop fuel control limits and adaptive learn limits. Upon detecting a fault condition, the system notifies the operator by illuminating the MIL and activating the appropriate fault action.

The action required by each fault shall be programmable by the OEM customer at the time the engine is calibrated. Diagnostic information can be communicated through both the service tool interface and the MIL lamp. With the MIL lamp, it is possible to generate a string of flashing codes that correspond to the fault type. These diagnostics are generated only when the engine is not running and the operator initiates a diagnostic request sequence such as repeated actuations of the pedal within a short period of time following reset. The MI-07 system uses an advanced speed-density control strategy for fuel, spark, and air throttle control. Key features include the following.

• Open-loop fuel control with fuel specific controls for LPG • Speed-load spark control with tables for dwell, timing, and fuel type • Speed-load throttle control with table for maximum TPS limiting G643(E) Service Manual Chapter 5. Engine Management System (EMS) 170