( 1) Ignition Coil ( 2) Ignition Module Figure 15. GM Ignition Module The rising edge of the VR signal is converted to a rising 5-volt signal by the ignition module. As the VR signal passes back through zero volts, a falling edge is created producing a square wave or digital signal, similar to the signal produced by a Hall effect sensor. This falling edge signal provides a stable engine position reference at all engine speeds for the SECM. SECM Small Engine Control Module (SECM) controller has full authority over spark and air. the SECM has 24 pins of I/O and is fully waterproof and shock hardened ( Figure 16 ).
To optimize engine performance and drivability, the SECM uses several sensors for closed loop feedback information. These sensors are used by the SECM for closed loop control in two main categories: Load/Speed Management Ignition Management Figure 16. Small Engine Control Module (SECM) The SECM monitors system parameters and stores any out of range conditions or malfunctions as faults in SECM memory. Engine run hours are also stored in memory. Stored fault codes can be displayed on the Malfunction Indicator Light (MIL) as flash codes or read by the Service Tool software through a CAN (Controller Area Network) communication link.
Battery power (12 Vdc) is supplied through the fuse block to the main power relay. The ignition key switch is used to energize the main power relay. A main power relay supplies 12 Vdc power to the SECM, fuel lock-off, and the Smart Coil. The SECM supplies positive voltage to the electronic throttle actuator, oil pressure switch and the coolant temperature sensor. Transducer or sensor power (+5 Vdc) is regulated by the SECM and supplied to the temperature/manifold air pressure sensor (TMAP), throttle position sensor (TPS), and the accelerator pedal position sensors (APP1 & APP2).
The SECM provides a constant voltage (VCC) to the Smart Coil Driver, transducer ground for the all sensors, and a low side driver signal controlling the fuel lock-off and MIL. SECM (Load/Speed Management) Drive by wire refers to the fact that the MI-07 control system has no throttle cable from the foot pedal (Figure 17) to the throttle body. Instead, the SECM is electronically connected both to the foot pedal assembly and the throttle body. The SECM monitors the foot pedal position and controls the throttle plate by driving a dc motor connected to the throttle. The dc motor actuates the throttle plate to correspond to the foot pedal position when the operator depresses the pedal.
The use of electronic throttle control (ETC) ensures that the engine only receives the correct amount of throttle opening for any given situation, greatly improving idle quality and drivability. Figure 17. Foot Pedal G643(E) Service Manual Chapter 5. Engine Management System (EMS) 176