A Throttle Position Sensor (TPS), ( Figure 18 ) which is integral to the Drive By Wire (DBW) throttle assembly, provides feedback for position control by monitoring the exact position of the throttle valve. NOTE: The DV-E5 is not a serviceable assembly. If the TPS sensor fails, the assembly should be replaced. Figure 18. Throttle Position Sensor (TPS) on DV- E5 Throttle SECM self-calibration and “cross checking” of the TPS is accomplished by comparing the TPS signal to a calculated throttle position in the SECM software (Predicted TPS).
In addition to the throttle position sensor, a temperature/manifold air pressure sensor (TMAP) is used to monitor intake manifold temperature and pressure ( Figure 19 ). This enables the SECM full control capabilities monitoring actual airflow in relationship to desired airflow. The TMAP sensor is a single unit incorporating both intake manifold temperature and manifold pressure measurement. Figure 19. TMAP Sensor The MI-07 system also performs minimum (min) and maximum (max) governing through the SECM and DBW throttle. For min governing, or idle speed control, the idle speed is fixed by the SECM. Unlike a mechanical system, the idle speed is not adjustable by the end user.
The idle speed is adjusted by the SECM based on engine coolant temperature. At these low engine speeds, the SECM uses spark and throttle to maintain a constant speed regardless of load. G643(E) Service Manual Chapter 5. Engine Management System (EMS) 177