Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

EMS Inspection and Repair • Fuel Temperature Sensor (FTS) -40°F to 266°F (-40єC to 130єC) range, 48K ohm to 57 ohm sensor range • HEGO (3) 0 to 1 V • Auxiliary Analog Input (2) 0 to 5 V • Battery Voltage (Vbatt) (1) 8-18 V With the exception of battery voltage, all inputs are 0-5 Vdc, ground referenced. Resolution should be 0.1% or better. Accuracy should be 2% or better.

Frequency/Position Inputs • Crankshaft position Variable reluctance (2-wire, 200 Vpp max) or 0-5 V Hall Effect with calibration selectable pull-up resistor for open collector sensors Permits speed resolution of 0.25 rpm and crankshaft position resolution of 0.5є • Camshaft position Variable reluctance (2-wire, 200 Vpp max) or 0-5 V Hall Effect with calibration selectable pull-up resistor for open collector sensors.

Digital Inputs • Oil pressure switch Normally open, internal pull-up resistor provided to detect external switch to ground • Transmission oil temperature switch Normally open, internal pull-up resistor provided to detect external switch to ground • Fuel select switch Three-position switch for bi-fuel applications to detect gasoline mode, LPG mode, and fuel off (center switch position) • Ground speed select switch Permits selecting two different maximum engine speeds • Vswitched Switched battery voltage Engine Control Module [ G643E ] The 48-pin Small Engine Control Module (SECM) and sensors provide the computational power, algorithm logic, sensor inputs and control outputs to control the system.

The SECM receives signals from the sensors, digitizes these signals, and then, through algorithms and calibration MAPs, computes the desired output response to effect control of fuel, spark and air to the engine. The SECM also provides a variety of other functions and features. These include system monitoring and diagnostics to aid in maintaining efficient system operation and auxiliary control. SECM/sensor inputs and control output specifica- tions are specific to the application, but include a selection of the following: Analog Inputs The 48-pin SECM is equipped with sufficient analog inputs for the following sensors.

Manifold Absolute Pressure (MAP) 1bar MAP, 0 to 5 V Manifold Air Temperature (MAT) -40°F to 266°F (-40єC to 130єC) range, 48 kohm to 85 ohm sensor range Throttle Position Sensor 1&2 (TPS1 & TPS2) 0 to 5 V • Foot Pedal Position 1&2 (FPP1 & FPP2) 0 to 5 V • Coolant Temperature Sensor (CTS) -40°F to 266°F (-40єC to 130єC) range, 48K ohm to 85 ohm sensor range G643(E) Service Manual Chapter 5. Engine Management System (EMS) 181