Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Outputs • Saturated injector drivers (4) 10A peak, 45 V max, 1 injector per channel capable of continuous on-time Driver circuit designed for minimum turn-on/turn- off delay Minimum pulse width resolution of 1 usec • FTV drivers (2) 10A peak, 45V max.

To drive an on/off fuel trim valve with a minimum impedance of 5 ohms Capable of continuous on-time Drive circuit designed for minimum turn-on /turn- off delay FTVs will be pulse width modulated between 8 and 40 Hz with a minimum pulse width resolution of 50 usec • Fuel lock-off solenoid valve Low side switch, 10A peak, 4A continuous 45 V max • Gasoline fuel pump drive Low side switch, 10A, 4A continuous 45 V max • Electronic Spark Timing (EST) (4) TTL compatible outputs Software configured for coil-on-plug ignition system • Throttle control (1) H-Bridge, 5A peak, 2.5A continuous at 2500 Hz PWM includes current feedback for diagnostic purposes.

• MIL (malfunction indicator lamp) Low side switch, sufficient to drive a 7W incandes- cent lamp continuously • CANBus CAN 2.0b serial communication for J1939 com- munications, programming and diagnostics. Requires proper termination resistance per CAN 2.0b. Crank Shaft Position Sensor [ G643E ] Component Location Description The Crankshaft Position Sensor (CKPS) is a hall effect type sensor that generates voltage using a sensor and a target wheel mounted on the crankshaft; During one crankshaft rotation there are the rectangular signals. The ECM calculates engine RPM by using the sensor’ signal and controls the the ignition timing. G643(E) Service Manual Chapter 5.

Engine Management System (EMS) 182