Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Schematic Diagram for G643E MAP (Manifold Absolute Pressure) Sensor [G643E and G643] Sensor Inspection 1. Turn ignition switch to OFF position and then disconnect CKPS connector. 2. Remove the CKPS from the engine. 3. Turn ignition switch to ON position. 4. Apply battery voltage to the terminal 1 and ground terminal 1 and ground terminal 3 of CKPS as shown in the figure. 5. Install a LED between +5V power and CKPS terminal 2, and then set a steel wheel (or anything made of steel ; hammer, wrench, bolt and nut etc.) at the CKPS's tip. 6. Rotate the steel wheel slowly and check if the LED flashes light.

• If the LED blinks, the CKPS works normally MAP sensor The manifold absolute pressure (MAP) sensor is a pressure sensitive variable resistor. It measures changes in the intake manifold pressure which result from engine load and speed changes, and converts this to a voltage output. The MAP sensor is also used to measure barometric pressure at start up, and under certain conditions, allows the ECM to automatically adjust for different altitudes. The ECM supplies 5 volts to the MAP sensor and monitors the ECM supplies 5 volts to the MAP sensor and monitors the voltage on a signal line. The sensor provides a path to voltage on a signal line.

The sensor provides a path to ground through its variable resistor. The MAP sensor in put affects fuel delivery and ignition timing controls in the ECM. Circuit Diagram (G643E) 1 2 3 MAP & IAT sensor 3 Sensor power B24 IAT signal B12 Sensor ground B1 MAP signal B18 E C M G643(E) Service Manual Chapter 5. Engine Management System (EMS) 183 M IAT M AP IA T 2 1 4