Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Circuit Diagram (G643) Sensor Inspection 1. Measure the voltage between terminals 1 and 4 of the MAP sensor connectors. Terminal 4 : MAP sensor ground Terminal 1 : MAP sensor output 2. Connect the electrical connector to the MAP/MAT sensor. Verify that the connector clicks/locks into place. 3. Connect the negative battery cable. IAT (Intake Air Temperature) Sensor [G643E and G643] MAP sensor The intake air temperature sensor (IAT Sensor), built in to the MAT sensor, is a resistor-based sensor detect the intake air temperature. According to the intake air temperature information frim the sensor, the ECM will control the necessary amount of fuel injection. 2.

If the voltage deviates from the standard value, replace the MAP sensor assembly. Removal 1. Disconnect the negative battery cable. 2. Disconnect the electrical connector from the MAP/MAT sensor. 3. Remove the two screws retaining the MAP/MAT sensor to the intake manifold. 4. Remove MAP/MAT sensor. Installation 1. Place the MAP/MAT Sensor in position on the intake manifold and install the two retaining screws. Tighten retaining screws to 6 N•m (53 lbf• ft) Circuit Diagram (G643E) MAP & IAT sensor 3 Sensor power B24 IAT signal B12 Sensor ground B1 MAP signal B18 E C M G643(E) Service Manual Chapter 5. Engine Management System (EMS) 184 Engine state Test specification Ignition SW.

ON 4~5V At idle 0.5~2.0V M IAT M AP IA T 2 1 4