Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Signal Wave Form ECT Senser Description The Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermister whose resistance changes with the temperature. The electrical resistance of the ECTS decreases as the temperature increases, and increases as the temperature decreases. The reference 5 V in the ECM is supplied to the ECTS via a resistor in the ECM. That is, the resistor in the ECM and the thermistor in the ECTS are connected in series. When the resistance value of the thermistor in the ECTS changes according to the engine coolant temperature, the output voltage also changes.

Sensor Inspection The amplitude of the signal output of the rear HO2S is small compared to the front HO2S because the rear HO2S detects emission gas purified by the catalytic converter. This illustration is the normal signal waveform of the rear HO2S at idle. Specification 1. Remove the engine coolant temperature sensor from the intake intake manifold. 2. With the temperature sensing portion of the engine coolant temperature sensor immersed in hot water, check resistance. ECT (Engine Coolant Temperature) Sensor [G643E and G643] Component Location 3. If the resistance deviates from the standard value greatly, replace the sensor. G643(E) Service Manual Chapter 5.

Engine Management System (EMS) 187 Temperature Rear HO2S Heater Resis- tance(Ω) Temperature Rear HO2S Heater Resistanc e(Ω) (℃) (℉) (℃) (℉) 20 68 9.2 400 752 17.7 10 212 10.7 500 932 19.2 200 392 13.1 600 1,112 20.7 300 572 14..6 700 1,272 22.5 Temperature ℃ (℉) ECTS Resistance(kΩ) 20(68) 2.31~2.59