Schematic Diagram (G643E) Oxygen Sensor (Post-Catalyst) [ G643E ] Component Location [CIRCUIT DIAGRAM] ECM HO2S (B1/S1) 4 A23 - HO2S HEATER (B1/S1) B13 - HO2S SIGNAL B1 - HO2S GND After Main Relay [HARNESS CONNECTORS] Description The rear heated oxygen sensor is mounted on the rear side of the Catalytic Muffler, which detects the catalyst efficiency. The rear heated oxygen sensor (HO2S) produces a voltage between 0V and 1V. This rear heated oxygen sensor is used to estimate the oxygen storage capability. If a catalyst has good conversion properties, the oxygen fluctuations are smoothed by the oxygen storage capacity of the catalyst.
If the conversion provided by the catalyst is low due to aging, poisoning or misfiring, then the oxygen fluctuations are similar to signals from the front oxygen sensor. Schematic Diagram (G643E) 2 1 4 3 C16 HO2S ( B1/S1 ) Signal Wave Form [CIRCUIT DIAGRAM] ECM HO2S (B1/S2) 3 A23 - HO2S HEATER (B1/S2) B19 - HO2S SIGNAL If you release the accelerator pedal suddenly after engine running about 2600 rpm, fuel supply will stop for short period and the O2 sensor service data will display values 200mV or lower. When you suddenly press on the accelerator pedal down, the voltage will reach 0.6 ~ 1.0 V.
When you let the engine idle again, the voltage will fluctuate between 200 mV or lower and 0.6 ~ 1.0 V. In this case, the O2sensor can be determined as good. B1 - HO2S GND After Main Relay [HARNESS CONNECTORS] C22 G643(E) Service Manual Chapter 5. Engine Management System (EMS) 186 3 1 2 4 2 1 1 2 3 4