Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Electronic Throttle Body [G643E and G643] Location Description The MI-07 system uses electronic throttle control (ETC). The SECM controls the throttle valve based on engine RPM, engine load, and information received from the foot pedal. Two potentiometers on the foot pedal assembly monitor accelerator pedal travel. The electronic throttle used in the MI-07 system is a Bosch 32mm electronic throttle body DV-E5. The DV-E5 is a single unit assembly, which includes the throttle valve, throttle-valve actuator (DC motor) and two throttle position sensors (TPS).

The SECM calculates the correct throttle valve opening that corresponds to the driver’s demand, makes any adjustments needed for adaptation to the engine’s current operating conditions and then generates a corresponding electrical (driver) signal to the throttle-valve actuator. Circuit Diagram [ G643E ] Circuit Diagram [ G643 ] [Harness Connectors] Inspection 1. Check for loose, dirty or damaged connectors and wires on the harness 2. Check the throttle assembly motor housing for coking, cracks, and missing cover-retaining clips 3. Check the resistance of TPS sensor. (refer as blow chart) G643(E) Service Manual Chapter 5.

Engine Management System (EMS) 192 SENSOR POINT TO POINT EXPECTED RANGE TPS (Throttle Position Sensor) TPS PIN 2(GND) TO PIN 6(TPS1 SIGNAL) 1.25KΩ +/- 30% TPS PIN 3(PWR) TO PIN 6(TPS1 SIGNAL) 1.25KΩ +/- 30% TPS PIN 1(+DRIVER) TO PIN 4(-DRIVER) ~3.0KΩ +/- 30%