Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

NOTE: A plastic O-ring spacer and an O-ring are inside the mixer/adapter assembly. Be careful not to lose these items when removing the assembly from the throttle (Figure 31). Figure 31. O-Ring and Spacer Within Mixer Adapter Assembly Figure 32. Throttle Adapter Mount Screws CA100 Certified Mixer Installation Steps Refer to Figure 30. 1. Install the vacuum port barb onto the mixer (9). 2. Install the fuel temperature sensor fitting (4) onto the mixer. 3. Install the fuel temperature sensor into the fitting. 4. Ins tall the four mounting screws that attach the throttle adapter (7) to the mixer. See Figure 32. Torque bolts to 30-40 lbf· in (3.39-4.52 N· m). 5.

Position the mixer/adapter assembly onto the throttle body (8), then drop in the four mounting bolts (6) and gently push down on the assembly until it rests on the throttle body. Be careful not to pinch the O-ring. (See Figure 31.) 6. Attach the mixer/throttle body assembly to the intake manifold, making sure gasket is in place. Tighten the four mounting bolts. 7. Connect the wiring harness to the throttle body. (See Figure 31 for location of connector.) Connect the fuel temperature sensor connector (5) to the sensor. 8. Install the vapor fuel inlet line (3) to the fuel temperature sensor fitting. 9. Install the two vacuum lines (2) to the mixer using the previous marks for identification.

Vacuum lines must be installed correctly for proper operation. 10. Install the air cleaner hose (1). Wiring harress connection VACUUM PORT BARB Used only on certified systems. Location may vary depending upon application. ALTERNATE VACUUM PORT BARB G643(E) Service Manual Chapter 6. LPG FUEL DELIVERY SYSTEM 198