Removal and Installation of CA100 Mixer for G643E Follow the procedures below for removal and reinstallation of the CA100 mixer. CA100 Certified Mixer Removal Steps 1. Gasket 2. Adapter 3. Fitting 4. Tmap 5. Washer 6. Bolt 7. Bolt 8. Gasket-ITB 9. ITB 10. O-Ring 11. O-Ring 12. Mixer 13. Adapter 14. Fuel Temp Sensor 15. Fitting 16. Apollo Adapter 17. Bolt Figure 30. CA100 Mixer in Certified System 1. Close the liquid outlet valve in the forklift cylinder or fuel storage container. 2. Purge the system of fuel by starting the engine and running until all trapped fuel in the system is exhausted and the engine shuts down. 3. Key switch in “OFF” position. 4. Remove the air cleaner hose (1). 5.
Mark the two vacuum lines (2) to the mixer for identification, as they must be reinstalled correctly for proper operation. Remove the two vacuum lines (2). 6. Remove vapor fuel inlet line (3) from the fuel temperature sensor fitting (4). 7. Disconnect the fuel temperature sensor connector (5). 8. Disconnect the wires leading to the electronic throttle body by pinching the lock tabs on either side of the wiring harness connector. (See Figure 31 for location of connector) 9. Loosen the four bolts (6) that secure the mixer/adapter/throttle body assembly to the intake manifold. 10. Remove the mixer (9), the adapter (7), and the throttle body (8) as an assembly by gently pulling upwards.
Take care not to drop anything down the intake manifold. 11. Gently wiggle and pull to separate mixer and adapter from the throttle body. Take note of the adapter orientation on the mixer, as it must be reinstalled correctly for proper fit on the throttle. 12. Remove the four mounting screws that attach the throttle body adapter to the mixer. 13. Remove the fuel temperature sensor (not shown) from the tee (4). 14. Remove the fuel temperature sensor fitting from the mixer. Take note of the fitting’s orientation on the mixer, as it must be reinstalled correctly for proper fit. 15. Remove the short vacuum port barb from the mixer.
(See Figure 32 for location of port barb on mixer.) 14 12 13 15 16 10 17 11 9 4 5 6 8 7 3 1 2 G643(E) Service Manual Chapter 6. LPG FUEL DELIVERY SYSTEM 197