Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Power Valve Adjustment 1. The power valve should only be adjusted after the idle screw has been adjusted properly. The engine and vehicle drive train and hydraulics should also be at normal operating temperatures. 2. Apply a load to the engine while the engine is operating above idle speed. Torque converter stall is the preferred operating mode for this test. If a torque converter speed test cannot be performed, the engine can be run at another speed (max governor), but a load must be applied by using hydraulics. NOTE : While adjusting the power valve, do not hold engine at load point for longer than 5-10 seconds.

Holding for a longer period of time will cause the fuel temperature to drop, which could adversely affect the power valve setting. 3. Monitor the output of the UEGO or HEGO sensor while the engine is at the higher speed with the load applied (phi = 1.00 to 1.05 is optimal). 4. If the phi reading is not at the desired level, bring the engine back to idle and adjust the power valve. 5. Bring the engine back to the higher speed with a load applied and verify the power valve setting. Adjust further as needed. 6. Once the power valve is set, bring the engine back to idle and verify the idle screw setting. G643 LP Fuel Systems Without O2 Sensor Idle Adjustment 1.

After the mixer is installed, start and warm up the engine to normal operating temperature (ECT>167°F [75°C]). Also ensure that the vehicle drive train and hydraulic systems are at normal operating temperatures per vehicle manufacturer recommendations. 2. Allow the engine to reach steady state at idle. 3. With the idle screw completely tightened clockwise, use a standard screwdriver to adjust the idle screw counterclockwise until a minimum average MAP value has been reached. The MAP value is displayed on the Service Tool screen. Power Valve Adjustment 1. The power valve should only be adjusted after the idle screw has been adjusted properly.

The engine and vehicle drive train and hydraulics should also be at normal operating temperatures. 2. Apply a load to the engine while the engine is operating above idle speed. Torque converter stall is the preferred operating mode for this test. If a torque converter speed test cannot be performed, the engine can be run at another speed (max governor), but a load must be applied by using hydraulics. The power valve should be adjusted to obtain maximum torque converter stall speed. NOTE : While adjusting the power valve, do not hold engine at load point for longer than 5-10 seconds.

Holding for a longer period of time will cause the fuel temperature to drop, which could adversely affect the power valve setting. 3. Once the power valve is set, bring the engine back to idle and verify the idle screw setting. Figure 43. Main Mixture Adjustment on Bottom of Mixer (partial view) G643(E) Service Manual Chapter 6. LPG FUEL DELIVERY SYSTEM 217