Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Chapter 7. BASIC TROUBLESHOOTING Preliminary Checks MI-07 systems are equipped with built-in fault diagnostics. Detected system faults can be displayed by the Malfunction Indicator Lamp (MIL) and are covered in Chapter 9, Advanced Diagnostics. However, items such as fuel level, plugged fuel lines, clogged fuel filters, and malfunctioning pressure regulators may not set a fault code and usually can be corrected with the basic troubleshooting steps described on the following pages. If engine or drivability problems are encountered with your MI-07 system, perform the checks in this section before referring to Advanced Diagnostics. NOTE:

Locating a problem in a propane engine is done exactly the same as with a gasoline engine. Consider all parts of the ignition and mechanical systems as well as the fuel system. Before Starting 1. Determine that the SECM and MIL light are operating. Verify operation by keying on engine and checking for flash of MIL light. When the ignition key is turned on, the MIL will illuminate and remain on until the engine is started. Once the engine is started, the MIL lamp will go out unless one or more fault conditions are present. If a detected fault condition exists, the fault or faults will be stored in the memory of the small engine control module (SECM).

Once an active fault occurs the MIL will illuminate and remain ON. This signals the operator that a fault has been detected by the SECM. 2. Determine that there are no diagnostic codes stored, or there is a diagnostic code but no MIL light. Visual/Physical check Several of the procedures call for a “Careful Visual/Physical Check” which should include: SECM grounds for being clean and tight Vacuum hoses for splits, kinks, and proper connection. Air leaks at throttle body mounting and intake manifold Exhaust system leaks Ignition wires for cracking, hardness, proper routing, and carbon tracking Wiring for pinches and cuts Also check:

Connections to determine that none are loose, cracked, or missing Fuel level in vehicle is sufficient Fuel is not leaking Battery voltage is greater than 11.5 volts Steering, brakes, and hydraulics are in proper condition and vehicle is safe to operate NOTE: The Visual/Physical check is very important, as it can often correct a problem without further troubleshooting and save valuable time. G643(E) Service Manual 227 Chapter 7. Basic Troubleshooting