Basic Troubleshooting Intermittents An intermittent fault is the most difficult to troubleshoot since the MIL flashes on at random, causing uncertainty in the number of flashes or the conditions present at the time of the fault. Also, the problem may or may not fully turn “ON” the MIL light or store a code. Therefore, the fault must be present or able to be recreated in order to locate the problem. If a fault is intermittent, use of diagnostic code charts may result in the unnecessary replacement of good components. Corrective Action Most intermittent problems are caused by faulty electrical connections or wiring. Perform careful visual/physical check for:
Poor mating of the connector halves or terminal not fully seated in the connector body (backed out) Improperly formed or damaged terminal. All connector terminals in problem circuit should be carefully reformed or replaced to insure proper contact tension Loose connections or broken wires Poor terminal to wire connection crimp If a visual/physical check does not find the cause of the problem, perform the following: (1) Drive the vehicle with a voltmeter or “Service” tool connected to a suspected circuit. Check if circuit is active and signal is reasonable. (2) Using the “Service” tool, monitor the input signal to the SECM to help detect intermittent conditions.
(3) An abnormal voltage, or “Service” reading, when the problem occurs, indicates the problem may be in that circuit. (4) If the wiring and connectors check OK, and a diagnostic code was stored for a circuit having a sensor, check sensor. An intermittent “Service Engine Soon” light with no stored diagnostic code may be caused by: Ignition coil shortage to ground and arcing at spark plug wires or plugs MIL light wire to ECM shorted to ground SECM grounds (refer to SECM wiring diagrams). Check for improper installation of electrical options such as lights, 2-way radios, accessories, etc.
EST wires should be routed away from spark plug wires, distributor wires, distributor housing, coil and generator. Wires from SECM to ignition should have a good connection. G643(E) Service Manual 234 Chapter 7. Basic Troubleshooting