Backfire Fuel ignites in intake manifold or in exhaust system, making loud popping noise. PRELIMINARY CHECKS Perform the visual checks as described at start of “ Basic Troubleshooting” chapter. Simulate condition by reviewing operation procedure practiced by vehicle operator. Related MIL Faults: EST faults / ETC faults / Encoder error Pre-catalyst O2 sensor faults Dieseling, Run-on Engine continues to run after key is turned “OFF,“ but runs very roughly. If engine runs smoothly, check ignition switch and adjustment. PRELIMINARY CHECKS Perform the visual checks as described at start of “ Basic Troubleshooting” chapter. Related MIL Faults:
EST faults / ETC faults / Pre-catalyst O2 sensor faults G643(E) Service Manual 241 Chapter 7. Basic Troubleshooting PROBABLE CAUSE CORRECTIVE ACTION Fuel system malfunction Perform fuel system diagnosis check: • Check for fuel leaks • Check for MIL faults • Check for damaged components Ignition system malfunction Check proper ignition coil output voltage with spark tester. Check spark plugs. Remove spark plugs, check for wet plugs, cracks, wear, improper gap, burned electrodes, or heavy deposits. Repair or replace as necessary. Check spark plug wires for crossfire; also inspect distributor cap, spark plug wires, and proper routing of plug wires. Check ignition timing.
Engine mechanical Check compression: look for sticking or leaking valves. Check intake and exhaust manifold for casting flash and gasket misalignment. Refer to Chapter 3 Engine Mechanical System. PROBABLE CAUSE CORRECTIVE ACTION Fuel system malfunction Check for fuel leaks or leaking injector. Ignition switching Make sure power to system is shut off when key is in OFF position. Fuel lock off valve Make sure lock off valve is closing properly. Ignition system malfunction Check spark advance at idle.