Rough, Unstable, Incorrect Idle, or Stalling Engine cranks OK, but does not start for a long time. Does eventually run, or may start but immediately dies. PRELIMINARY CHECKS Perform the visual checks as described at start of “Basic Troubleshooting” chapter. Check for vacuum leaks. Check that SECM grounds are clean and tight. See SECM wiring diagram G643(E) Service Manual 242 Chapter 7. Basic Troubleshooting PROBABLE CAUSE CORRECTIVE ACTION Fuel system malfunction Monitor oxygen feedback to help identify the cause of the problem. If the system is running lean or if the system is running rich evaluate further i.e. dither valve duty cycle and injector pulse width.
Check for incorrect minimum idle speed that may be caused by foreign material accumulation in the throttle bore, on the throttle valve, or on the throttle shaft. Check that the injectors are clean and functioning. Check for liquid fuel in propane pressure regulator hose. If fuel is present, replace regulator assembly. The pre-catalyst oxygen (O2) sensor should respond quickly to different throttle positions. If it does not, then check the pre-catalyst O2 sensor for contamination. If the pre-catalyst O2 sensor is aged or contaminated, the SECM will not deliver correct amount of fuel, resulting in a drivability problem.
Fuel container empty Check for LPG vapor from LPG liquid outlet valve on tank. Fill fuel container. Do not exceed 80% of liquid capacity. Ignition system malfunction Check ignition system; wires, plugs, rotor, etc. LPG pressure regulator malfunction Test regulator operation and pressure. See Chapter 6 Tests and Adjustments Air/fuel mixer malfunction Check mixer. Component malfunction Check throttle for sticking or binding. Check PCV valve for proper operation by placing finger over inlet hole in valve end several times. Valve should snap back. If not, replace valve. Check alternator output voltage. Repair if less than 9 or more than 16 volts.
Engine mechanical Perform a cylinder compression check. See Chapter 3 Engine Mechanical System.