Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Chart T-1 Restricted Exhaust System Check Proper diagnosis for a restricted exhaust system is essential before replacement of any components. The following procedures may be used for diagnosis, depending upon engine or tool used. Check Atpre - Catalystoxygen (O2) Sensor 1. Carefully remove pre-catalyst oxygen (O2) sensor. 2. Install exhaust backpressure tester or equivalent in place of O2 sensor using Snap-On P/N EEVPV311A kit and YA8661 adapter or Mac tool (see illustration). 3. After completing test described below, be sure to coat threads of O2 sensor with anti-seize compound prior to re-installation. Illustration Notes 1. Backpressure gage 2. Pre-catalyst Oxygen (O2) sensor 3.

Exhaust manifold Diagnosis: 1. With the engine idling at normal operating temperature, observe the exhaust system backpressure reading on the gage. Reading should not exceed 1.25 psig (8.61 kPa). 2. Increase engine speed to 2000 rpm and observe gage. Reading should not exceed 3 psig (20.68 kPa). 3. If the backpressure at either speed exceeds specification, a restricted exhaust system is indicated. 4. Inspect the entire exhaust system for a collapsed pipe, heat distress, or possible internal damage, split welds, or cracked pipe. 5. If there are no obvious reasons for the excessive backpressure, the catalytic converter is restricted and should be replaced using current recommended procedures.

G643(E) Service Manual 249 Chapter 7. Basic Troubleshooting