Diagnostic Aids for Rich / Lean Operation (*) The duty cycle injector pulse width criteria for lean or rich operation apply only if the O2 sensor is functioning properly. If the sensor is not operating properly the criteria may be reversed. Rich Operation LP (Trim valve duty cycle>90%) Inspect hoses from AVV port (port on bottom of mixer) to trim valves and regulator for leaks or blockages, replace as necessary.
Inspect in-line orifices for blockages (in wye), replace as necessary Check trim valves for proper operation, replace as necessary Check regulator out pressure, replace if out of spec Inspect fuel cone for damage, replace mixer assembly as necessary Lean Operation LP (Trim valve duty cycle Check for vacuum leaks, replace hoses, o-rings, and gaskets as necessary Check balance line for blockage, replace as necessary Check vapor hose for restrictions, replace as necessary Check trim valves for proper operation, replace as necessary Check regulator out pressure, replace if out of spec G643(E) Service Manual 248 Chapter 7.
Basic Troubleshooting SERVICE TOOL ITEM RICH LEAN Pre-catalyst O2 A/ D counts Consistently > 250 Consistently Pre-catalyst O2 sensor switching between high and low Always high ADC Always low ADC Trim valve duty cycle > 90% Malfunction codes • Pre-catalyst O2 sensor failed rich • Pre-catalyst O2 sensor high • Fuel adapts • Pre-catalyst O2 sensor failed rich • Pre-catalyst O2 sensor high • Fuel adapts Closed loop operation Stuck in open loop Stuck in open loop