Camshaft (1) Torque for camshaft sprocket bolts ................................................ 20 N· m (15 lb· ft) Balance Shaft (1) Front Bearing Journal Diameter ...... 55.985 to 55.001 mm (2.1648 to 2.1654 in) (2) Torque for retainer mounting bolts .............................................. 12 N· m (106 lb· ft) (2) Rear Bearing Journal Diameter ........ 38.084 to 38.100 mm (1.4994 to 1.500 in) Rear Bearing Journal Clearence .......... 0.0254 to 0.09144 mm (.001 to .0036 in) (3) End play for the camshaft ..............0.0254 to .02286 mm (.001 to .009 in) (3) Balance Shaft Drive Gear Bolt ................................................
20 N· m (15 lb· ft) Torque plus 35 Degrees (4) Diameter of the surface journals for the camshaft bearings new ..............51.03 to 51.05 mm (2.009 to 2.010 in) (4) Balance Shaft Retainer Bolt .............................................. 14 N· m (124 lb· ft) NOTE : Balance shaft must be timed to camshaft gear. G643 (E) Service Manual Chapter 3. Engine Mechanical System 38