Lubricating Oil Recommendations and Specifications QSB4.5 and QSB6.7 Page V-8 Section V - Maintenance Specifications Lubricating Oil Recommendations and Specifications General Information The fuel sulphur content should not exceed 0.5 mass percent sulphur. If the fuel sulphur content is greater than 0.5 mass percent sulphur, seek advice from your local Cummins® Distributor. For recommendations of fuel for Cummins® engines, refer to Fuel for Cummins® Engines, Bulletin 3379001. CAUTION CAUTION Extending the oil and filter change interval beyond the recommendations will decrease engine life due to factors such as corrosion, deposits and wear. Cummins Inc. does not recommend the use of A.C.E.A.
E4/MB 228.5 formulation oils, which do not attain one or more of the following lubricant qualifications: A.P.I. CH-4. CI-4, A.C.E.A. E5. E7, C.E.S. 20071, C.E.S. 20072, C.E.S. 20076, C.E.S. 20077, C.E.S. 20078. If A.C.E.A. E4/MB 228.5 formulation oils, which do not comply with the oil specifications listed above, are used in Cummins® automotive engines, problems such as wear to overhead, sliding tappets, camshaft and crankshaft bearings may be experienced. CAUTION The use of quality engine lubricating oils, combined with appropriate oil drain and filter change intervals, is a critical factor in maintaining engine performance and durability.
Extending the oil and filter change interval beyond the recommendations will decrease engine life due to factors such as corrosion, deposits and wear. NOTE: The responsibility is with the owner. If recommendations are ignored, warranty could be affected. NOTE: A.C.E.A. = Association des Constructeurs Europйen d'Automobiles, A.P.I. = American Petroleum Institute and C.E.S. = Cummins® Engineering Standard.