DEUTZ AG BFM 1012/1013 — Despiece y ensamblado conjunto de moteur

Demontage und Montage, Motor komplett Disassembly and reassembly of complete engine Dйmontage et montage moteur complet Despiece y ensamblado conjunto de motor English Franзais Espacol 212. Tension V-belt. Tighten bolts with a torque of 21 ± 2 Nm. 212. Tendre la courroie trapйzoпdale et serrer les vis au couple de 21 ± 2 Nm . 212. Tensar la correa trapezoidal. Apretar los tornillos con un par de 21 ± 2 Nm . 213. Check V-belt tension with belt tension gauge. 213. Contrфler la tension de la courroie trapйzoпdale а l’aide d'un tensiomиtre.

Largeur du dos de la courroie 10 mm Premiиre monte ____ 450 ± 50 N Contrфle aprиs 15 min de marche Sous charge ______ 300 ± 50 N Aprиs rйutilisation __ 300 ± 50 N 213. Comprobar la tensiyn de la correa utilizando un verificador de tensiyn. Ancho de correa 10 mm Primer montaje ____ 450 ± 50 N Control tras una marcha de 15 min.

bajo carga 300 ± 50 N Para reutilizaciyn ___ 300 ± 50 N Belt back width 10 mm Initial assembly ____ 450 ± 50 N Check value after 15 min.of operation under load 300 ± 50 N When reusing belt __ 300 ± 50 N Belt back width 13 mm Initial assembly ____ 550 ± 50 N Check value after 15 min.of operation under load 400 ± 50 N When reusing belt __ 400 ± 50 N Ancho de correa 13 mm Primer montaje ____ 550 ± 50 N Control tras una marcha de 15 min. bajo carga 400 ± 50 N Para reutilizaciyn ___ 400 ± 50 N Largeur du dos de la courroie 13 mm Premiиre monte ____ 550 ± 50 N Contrфle aprиs 15 min de marche Sous charge ______ 400 ± 50 N Aprиs rйutilisation __ 400 ± 50 N 214. Position V-belt. 214.

Monter la courroie. 214. Colocar la correa trapezoidal. 215. Tension V-belt. Tighten bolts with a torque of 30 Nm . 215.Tendre la courroie trapйzoпdale et serrer les vis au couple de 30 Nm . 215. Tensar la correa trapezoidal. Apretar los tornillos con un par de 30 Nm . 4 4.00.73