Komatsu — 500 HOUR LUBRICATION AND MAINTENANCE CHECKS

Maintenance - Section 4 OM4026.1 7/01 Page 4-10 Lubrication & Service 500 HOUR LUBRICATION AND MAINTENANCE CHECKS Maintenance requirements for every 10, 50, & 250 hour Lubrication and Maintenance Checks should also be carried out at this time. NOTE: “Lube Key” references are to the Lubrication Specification Chart. 1. FINAL DRIVE CASE BREATHERS - Remove breather elements for motorized wheels and clean or replace elements. 2. HYDRAULIC SYSTEM FILTERS - Replace tank breathers and high pressure filter elements. Check oil level. Add oil as necessary. Lube Key “B”. 3. HYDRAIR ® SUSPENSION - Check for proper pis- ton extension (front and rear). 4.

THROTTLE AND BRAKE PEDAL (NOT SHOWN) - Lubricate treadle roller and hinge pins with lubri- cating oil. Lift boot from mounting plate and apply a few drops of lubricating oil between mounting plate and plunger. 5. HOIST LIMIT SWITCH (NOT SHOWN) - Check operation. Clean and adjust as necessary. 6. HOIST ACTUATOR LINKAGE (NOT SHOWN) - Check operation. Clean, lubricate, and adjust as necessary. 7. PARKING BRAKE (NOT SHOWN) - Refer to the Shop Manual, Section "J", PARKING BRAKE MAINTENANCE, and perform the Inspec- tion recommended. 8. Reserve Engine Oil System (Optional) a. Check electrical system connections for tight- ness, corrosion and physical damage.

Check battery, oil pressure switch, junction boxes, remote control fill box and circuit breakers. b. Examine all electrical cables over their entire length for possible damage. c. Examine all hoses, including those on the re- serve tank and the ones leading to and from the engine, for leaks, cracks or damage. Check all fittings for tightness, leakage or damage. Truck Serial Number ___________________________ Site Unit Number ______________________________ Date: Hour Meter ______________ ________________ Name of Service person _________________________ COMMENTS √’d INITIALS