Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

OM4026.1 7/01 Maintenance - Section 4 Lubrication & Service Page 4-9 4. COOLING SYSTEM - a. Check cooling system for proper coolant mix- ture. Add coolant mixture as required. b. COOLANT FILTERS - Change coolant filters. Refer to engine manufacturer’s maintenance manual for coolant filter replacement instruc- tions and proper coolant mixture instructions. 5. REAR WHEEL MOUNTING - Using a mirror on a long rod and a flashlight, inspect where possible, all inner and outer wheel mounting nuts/studs for any evidence of looseness, damage, or missing hardware. If wheel mounting nuts/studs must be secured or replaced, the outer wheel must be removed for access.

Refer to the Shop manual, Section “G”, for these procedures. 6. REAR AXLE HOUSING - Check the rear axle hous- ing for fluid leaks by removing the two drain plugs on the bottom of the axle housing. If fluid is pre- sent, the cause must be found and corrected be- fore releasing truck to operation. 7. STEERING LINKAGE - Check torque on pin retain- ing nuts (steering linkage), 525 ft.lbs. (712 N.m) torque. Check torque on tie rod retaining cap- screws, 310 ft.lbs. (420 N.m) torque. 8. MAGNETIC PLUG - Remove magnetic plugs from front hub covers and inspect for debris. Clean the plugs and perform any necessary repairs. *9.

HYDRAULIC SYSTEM FILTERS - Replace filter elements only after the initial 250 hours of operation; then at each 500 hours of operation thereafter. Check oil level. Add oil as necessary. Lube Key “B”. *10. MOTORIZED WHEEL GEAR CASE - Refer to the G.E. planned maintenance manual and specific motorized wheel shop manual. 11. BATTERIES (NOT SHOWN) - Check electrolyte level and add water if necessary. * These checks are required only after the first 250 hours of operation (such as: the commissioning of a new truck, or after a new or rebuilt component installation), check: COMMENTS √’d INITIALS