Komatsu — 10 HOUR (SHIFT) LUBRICATION AND MAINTENANCE CHECKS

Maintenance - Section 4 OM4026.1 7/01 Page 4-4 Lubrication & Service 10 HOUR (DAILY) INSPECTION Prior to each operating shift, a “walk around” inspec- tion should be performed. Check the truck for general condition. Look for evidence of hydraulic leaks; check all lights and mirrors for clean and unbroken lenses; check operator’s cab for clean and unbroken glass; check frame, sheet metal and body for cracks. Notify the proper maintenance authority if any discrepancies are found. Give particular attention to the following:

Truck Serial Number ____________________________ Site Unit Number ______________________________ Date:______________Hour Meter_________________ Name of Service person_________________________ NOTE: “Lube Key” references are to the Lubrication Specification Chart. 10 HOUR LUBRICATION AND MAINTENANCE CHECKS 1. FAN DRIVE AND TURBOCHARGERS - Check for leaks, vibration or unusual noise. Check alternator and fan belts for proper tension, condition and for alignment. 2. RADIATOR - Check coolant level and fill with proper mixture as shown in Cooling System Recommen- dation Chart. Refer to Engine Manual for proper coolant additives. 3. ENGINE - Check oil level on dipstick.

Refer to engine manufacturer’s shop manual for oil recom- mendations. (Lube Key “A”). NOTE: If truck is equipped with a reserve engine oil tank, the oil should be visible in the center (middle) sight gauge. If not, add oil to reserve tank until oil is visible in top sight gauge . Also, with engine running, check operation of the LED indicator light. See below for description of LED Light Signals. 4. FUEL FILTERS (Fuel Separators).- Drain water from bottom of each filter housing. Inspect exhaust piping for security. 5. HYDRAULIC TANK - Check oil level in tank, add oil if necessary. Refer to “Hydraulic Tank Service”. Oil should be visible in sight glass. - DO NOT OVERFILL. Lube Key “B”. 6.

FUEL TANK - Fill as required. LED Light Signals: Steady - Pump 1 is withdrawing oil from the engine sump and bringing down the oil level. Regular Pulsing - Pump 2 is returning oil to the engine sump and raising the oil level. Irregular Pulsing - Oil is at the correct running level. COMMENTS √’d INITIALS