OM4026.1 7/01 Maintenance - Section 4 Lubrication & Service Page 4-5 10 HOUR (DAILY) INSPECTION (continued) 7. AIR CLEANERS (NOT SHOWN) - Check air cleaner vacuum gauges in operator cab. The air cleaner(s) should be serviced, if the gauge(s) shows the following maximum restriction: Komatsu SSDA16V160 Engine: 25 in. of H 2 O vac- uum. Refer to the shop manual, Section “C” for servicing instructions for the air cleaner elements. Empty air cleaner dust caps. NOTE: After service, push the reset button on face of gauge to allow the gauge to return to zero . 8. WHEELS AND TIRES - a. Inspect tires for proper inflation and wear. b. Inspect for debris embedded in cuts or tread. c.
Inspect for damaged, loose, or missing wheel mounting nuts/studs. 9. BODY-UP SWITCH (NOT SHOWN) - Clean sensing area of any dirt accumulation and check that wiring is intact. 10. CAB AIR FILTER (NOT SHOWN) - Under normal operating conditions, clean every 250 hours. In extremely dusty conditions, service as frequently as required. Clean filter element with mild soap and water, rinse completely clean and air dry with maximum of 40 psi (275 kPa). Reinstall filter. 11. AUTOMATIC LUBE SYSTEM - a. Check grease reservoir; fill as required. Lube Key “D”. b. When filling reservoir, check grease filter indicator. Clean or replace grease filter if indicator detects a problem. c.
Inspect system and check for proper operation. Be certain the following important areas are receiv- ing adequate amounts of grease. Lube Key “D”. Steering Linkage Final Drive Pivot Pin - Rear Hydrair ® Suspension Pin Joints - Upper & Lower Body Hinge Pins - Hoist Cylinders Pins - Upper & Lower Anti-sway Bar - Both Ends 12. COOLING AIR DUCTWORK - Inspect ductwork from blower to rear drive case to be certain that ductwork is secure and undamaged and there are no cooling air restrictions. COMMENTS √’d INITIALS