Toyota — Toyota FBMF 16-30 Service Manual

4-31A 3. EHPS EHPS (Electronically Controlled Full Hydraulic Power Steering) is adopted in some counterbalanced electric powered forklift models (5FBE, FBMF, etc.). A mechanism that electronically controls the pump motor rotation for hydraulic pressure generation is added to the hydrostatic type power steering to make the motor run only during steering operation so as to save energy. When the steering wheel is rotated, the rotating torque is detected by a torque sensor which sends an electric signal to the controller. The controller receives the signal and sends the corresponding chopping instruction for motor rotation to a transistor.

The hydraulic components of the hydrostatic type power steering mechanism in the EHPS are not explained here because they are almost the same in structure and function with those explained elsewhere. The chopping control for motor rotation varies with the model. It is roughly classified into the type using an electrical torque sensor (FBMF series) and the type using an oil pressure switch at the steering oil control valve (5FBE series).

OUTLINE Torque sensor PS cylinder PS valve Controller EHPS FOR FBMF SERIES Leaf spring 1) Torque Sensor The torque sensor consists of the mechanical block that provides displacement between the input and output shaft rotation angles according to the rotating torque generated by steering wheel rotation and the sensor block that generates an electric signal according to the angle displacement. The mechanical block consists of the input shaft directly rotated by the steering wheel rotating torque, output shaft connected to the power steering control valve, and the leaf spring for retaining the neutral position. Input shaft Output shaft Stopper pin Torque Sensor Mechanical Block