4-31B When the steering wheel is in its neutral position, the input and output shafts are held in the neutral position by the leaf spring. When the input shaft is rotated by the steering wheel, the output shaft is not rotated immediately because of the reaction force from the tires transmitted through the control valve. As a result, an angle difference is generated. This difference is converted to an electric signal in the sensor block explained below. Input shaft Sensor circuit Coil 1 Coil 2 Coil 3 Core Core Coil 3 Output shaft 2) Sensor Block The sensor block consists of the resonance circuit and the sensor circuit.
In the sensor circuit, an electrical vibration (oscillatory current) flows through coil 1-1 in each of oscillation circuits A and B. When the oscillatory current flows through coil 1-1, a current is generated in coil 2 by the induced electromotive force and it flows through the resonance circuit including coil 3 and a capacitor. In the resonance circuit, variation in the positional relationship between coil 3 and the core (due to torsional angle difference between the input and output shafts) changes the oscillation frequency and amplitude. As a result, coil 1-2 provided opposite to coil 2 can receive a signal corresponding to the positional relationship between coil 3 and the core.
In this way, the sensor circuit provides an output representing the torsional angle difference between the input and output shafts. Two pairs of resonance circuits are provided on the shafts, to which oscillation circuits A and B correspond. This configuration minimizes the influence of temperature on the torque sensor characteristic.
Coil 1-2 Input shaft Oscillation circuit B Oscillation circuit A Coil 2 Coil 1-1 Output F/V converter circuit Offset adjusting circuit Gain adjusting circuit Coil 3 Core Output shaft Failsafe circuit FET module F3 Battery DMps FET 3) Controller Shunt The controller makes the motor run whenever necessary at the required speed by chopping the FET according to the output from the torque sensor. Display SPS board Torque sensor